Sub-Driver 3.5 mod 2 -- **SOLD**

[ericpw8818]

Up for grabs is a Sub-Driver 3.5 mod two from Caswell. The system is set up for snort operations. Included is the following:

Sub-Driver 3.5 Cylinder with two motor end cap
Two Standard Futaba servos
Large Snort system with controller
ADF2 Angle Driver
SES-II switch
Y-harness
4 cli-con connectors

This unit was the kit which was assembled and never completed. I am moving on to other endeavors and have to let this go. I will include shipping in the US.
All Paperwork will be included. Sold as is. PayPal preferred. Please Email me: EricPW8818 (at) aol.com

Asking $450

Thank you
Eric

[ccontrol]

Re: Sub-Driver 3.5 mod 2

What's the capacity of the ballast tank?
If you're not sure, tell me the inside dimensions of the tank.

Thanks!
Steve

[ericpw8818]

Re: Sub-Driver 3.5 mod 2

Not sure of capacity but it is 8 1/2" long inside.

[JWLaRue]

Re: Sub-Driver 3.5 mod 2

Given a length of 8.5 inches and an internal diameter of 3.25 inches (wall thickness is 1/8th inch?), then the volume would be 70.5 cubic inches.

volume = pi * radius-squared * length

-Jeff

[salmon]

Re: Sub-Driver 3.5 mod 2

The battery compartment looks really small, what was this going into?

[ericpw8818]

Re: Sub-Driver 3.5 mod 2

The subdriver was set up with the battery terminals
Heading to the wet space in the hull. The forward compartment
Is a void space for more air for the snort system. This was
Going in to a 1/96 Oscar so there needed to be some extra
Volume.

Eric

[ericpw8818]

Re: Sub-Driver 3.5 mod 2

SOLD