Attention all registered users. The new forum upgrade requires you to reset your password as you logon for the first time.
To reset your password choose this option that is displayed when you attempted to login with your username: "Forgotten your password? Click here!"
You will be sent an e-mail to the address that is associated with your forum account. Follow the simple directions to reset your password.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Do you think this would work faster with a small soldering, or wood-burner tip? You wouldn't need the extra cement to soften the styrene, and not need to push as hard making it easier on the hands. What do you think—something to try?
If you talking about having the soldering iron or woodburning tool ON and giving this a try... I'd STRONGLY advise against that. Chances are high you'll burn the thin plastic (possibly right through it) and put your model (and yourself) at risk of harm.
The technique I propose is very easy, and not a lot of pressure is required... it's not hard on the hands at all. The liquid cement (which is fairly cheap) softens the plastic to prevent cracking it when you press the tool into it.
Thanks Glenn, but what's model building without risk. I like Xtreme model building. I'm going for it! I'll let you know how it turns out. And if it's too easy, I'll try softening my styrene with a drop of gasoline. Woo hoo!
Just kidding of course, but sounds like the makings of a new reality show.
Comment