Firstly, I don't like to think of myself as "disabled", but rater a work in progress. Ten years ago I was diagnosed with Asperger's and subsequently then went through a terrible period of doctor prescribed medication experiments to find something that worked. In the process one of the meds caused permanent nerve damage to my right side. Most of the time it isn't too bad, but recently it's been getting worse. The problem is tremors in my right had, and several areas in its range of motion that cause it to loose control. It's a little like Parkinson's, but just in one arm.
So what I'm wondering is, does anyone have any advice for me when it comes to cutting material with a Dremel and fine detailing. So far I've managed by having my upper arm held close to my torso, but it's getting really awkward now that I'm half way done with the cut-to-fit WTC.
So what I'm wondering is, does anyone have any advice for me when it comes to cutting material with a Dremel and fine detailing. So far I've managed by having my upper arm held close to my torso, but it's getting really awkward now that I'm half way done with the cut-to-fit WTC.
Comment