Attention all registered users. The new forum upgrade requires you to reset your password as you logon for the first time.
To reset your password choose this option that is displayed when you attempted to login with your username: "Forgotten your password? Click here!"
You will be sent an e-mail to the address that is associated with your forum account. Follow the simple directions to reset your password.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hi all
can anybody supply me with info
on how to fit control linkages to a rc seaview i am doin?
rudders no prob
just linkakes pref on 1 control rod
many thx
theraven
Best thing is to use two servos for the dive planes. First servo is connected to the stern and bow (in the forward wing) planes - these are used for pitch control. Second servo controls the sail planes for depth control. The stern and bow planes move in oppositte directions - bow planes move up, stern planes move down. For the Moebius SEAVIEW, I used 36" long brass rods to make up the bow plane linkage. These are connected to the stern plane linkage with some Dubro or Great Planes wheel collares (be sure to replace the mild steel set screws with stainless).
Comment