Attention all registered users. The new forum upgrade requires you to reset your password as you logon for the first time.
To reset your password choose this option that is displayed when you attempted to login with your username: "Forgotten your password? Click here!"
You will be sent an e-mail to the address that is associated with your forum account. Follow the simple directions to reset your password.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
maybe check out a few static modelling sites, like http://www.modelshipwrights.com how those people make their own PE.
PE is much more common in 1/350 scale shipbuilding and suchlike.
I have no own experience with PE.
for etching tools you also might want to check out the electronics
DIY sites and shops. But I'm sure you knew that already.
That micro-mark set is a good way to learn, but if you are wanting to do a sheet of any size, that kit will limit you. Try something from Mg chemical. I don't think you end up paying anymore in the long run either. They post a pdf app guide on there too. A very easy process once you get the hang of it.
Comment