Auto Leveler Problem

[nelix6030]

I have one of subtechs original Autolevelers and I seem to have a problem. On a level surface it seems to be way off, I have to tilt it pretty dramatically to get to that happy middle area where the servo wil travel in both directions with a tilt. Is there anything I can do, or is the little giro just messed up?

Kyle

[skip asay]

Kyle -

It sounds like you

Kyle -

It sounds like you have either -2 or -3. These used a liquid level sensor and I recall that I had a bad batch of them a bunch of years ago. I happen to have a few (very few) sensors left so if you want, send it to me and I'll replace it for you.

PM me for address.

Skip Asay

[nelix6030]

Thanks!

Skip, you are quite the gentleman. Its an APC-3, I am more then happy to pay shipping and handling both ways. I will PM you.

You know I have been a member off and on and its people like you that make this hobby great.

Thanks again.

Kyle

[junglelord]

This is EXACTLY why all

This is EXACTLY why all my business has come to this forum.
Kudos to all the true gentlemen of this hobby who are on this forum.
Cheers
Dean

[hampboats]

Funny thing about the unit

I also had one that did the same thing. But what I found out was that it worked perfectly upside. By accident, it tipped over while I was working one it and that's when I noticed that it worked. I replaced the sensor from and old one that had been damaged. But if you place it upside down and run your sub inverted, your problem will be solved.