Attention all registered users. The new forum upgrade requires you to reset your password as you logon for the first time.
To reset your password choose this option that is displayed when you attempted to login with your username: "Forgotten your password? Click here!"
You will be sent an e-mail to the address that is associated with your forum account. Follow the simple directions to reset your password.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I was just thinking, why not use a magnetic actuator for control surfaces? The ones like those used on micro-airplane models. These are proportional, they could mounted "wet" and therefore you would have less problems to deal with as far as sealing issues. Just a thought.
Does any one have any input on this idea. I am thinking about using it for a micro sub idea that I have, but I think that it could be applied to larger model designs as well. I would like some thoughts on this if possible.
Tweet
Comment