Attention all registered users. The new forum upgrade requires you to reset your password as you logon for the first time.
To reset your password choose this option that is displayed when you attempted to login with your username: "Forgotten your password? Click here!"
You will be sent an e-mail to the address that is associated with your forum account. Follow the simple directions to reset your password.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am attempting to build my 2.5" D&E cylinder. Attached is a photo of a part. Can someone identify the reasoning with the float and what the proper angle is? Any in-progress photos would be appreciated.
It's a gas saver device. When the tank is fully blown the float should lay on the bottom of the tank, and disengage the valve releasing the gas. Dave Merriman would be the best person to give you advice, as he made them.
Tweet
Comment