Tweet
I have seen some questions about X-tails and X-tail linkages. I am in no way an expert but thought I would show some linkage photos to show how simple they are. Basically they are just standard vertical, and horizontal surfaces turned 45 degrees. Each surface is not controlled by a separate servo; they are connecter together so two will work off the same servo. All the mixing is done electronically with an X-tail mixer like the Subtech unit. You will find they will spoil you with how well they turn. BD.
Edited By Bigdave on 1161695394
Edited By Bigdave on 1161695394
Tweet
Tweet
Comment