Tweet
I want to glue 3D printed material to itself???
- Attention all registered users. The new forum upgrade requires you to reset your password as you logon for the first time. To reset your password choose this option that is displayed when you attempted to login with your username: "Forgotten your password? Click here!" You will be sent an e-mail to the address that is associated with your forum account. Follow the simple directions to reset your password.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment