Gaskets and seals for SB-1 Neptune Thunder Tiger submarine

[hampboats]

I have a fully operational SB-1 submarine that I converted to the 007 Neptune and I also have another SB-1 that I use for parts. I would like to sell the parts sub. I have completely stripped all of the electronics and pump but left the WTC intact with the servos and motor. Therefore, the parts sub could become operational by adding a ballast system. I am concerned about letting the boat go because the parts boat is my only source for the two WTC gasket, the clear end caps large o rings and the motor shaft seals. Has any gotten a source for the replacement of these items. Also, the forward cone part is missing. If anyone has one they don't need let me know.

[hampboats]

more photos

[wlambing]

The specs for the o-rings were published in some literature that came with the boats, depending on which "version" you got. The Tech manual also mentioned the specific size for each as you proceed through the steps. Perhaps someone could copy theirs for you?????

[salmon]

Can't upload what I have....2MB limit. The smallest manual I have is 3.9MB.

[hampboats]

Thanks, I have the original manual.

[wingtip]

Dave i had no idea you were selling this. lets talk. I do have a machine shop that made my front clear endcap and can have another made. I can have them make the rear one as well if i remove it and let them put it on their coordinate measuring machine to measure it like they did my front endcap.