meeting belgie 9/10 oktober

[raalst]

9 & 10 oktober is er een meeting in belgie.

meer informatie

mijn kilo is bijna af, dus een goed excuus om te varen
vanuit den haag plm 200 kilometer, recht onder eindhoven en
recht naast sittard



Edited By raalst on 1094508584

[toneburst]

Dan gaan we elkaar daar

Dan gaan we elkaar daar tegenkomen....
Voor mij iets verderderder reizen, maar toch!

Jos

[raalst]

Leuk !

Ik mag (!)

Leuk !

Ik mag (!) de zondag. Ben jij er het hele weekeinde ?
Laat me even weten hoe ik je herken. enne... boot bij je ?

groeten, Ronald

Ps nu een tiefe/lageregler in de Kilo aan het zetten. Zonder
doet 'ie het goed, maar ik ben te slecht in het op diepte
houden.

[toneburst]

Hallo Ronald,

ik ben er beide

Hallo Ronald,

ik ben er beide dagen! Mijn ouders wonen een uurtje rijden van Houthalen, en rij dus za- op zondag heen en weer...

'Most wanted' identificatie is verzonden aan jouw email-postbus.

Jos.

[raalst]

got it !
nice stuff...

got it !
nice stuff...

[toneburst]

Thanks Ronald!

just thought it'ld be

Thanks Ronald!

just thought it'ld be nice to stick to English...
Did you know Mr. Engel & Mr. Brüggen have been invited to come to the Hengelhoef sub-meet? As far as I understood they have reacted positively. So if you thought about ordering orf buying something, or need some advise or have some remarks on their products this might be the ideal moment.
I do have some remarks about the Lafayette..

Jos

[raalst]

yep, I need a few

yep, I need a few "gestangedurchfuhrungen"
and possibly a "lageregler" for the Kilo.

Hopefully a lot of germans are also turning up.
Their boats are always impressive pieces of
engineering. I really want to understand how other
people made their axle watertight. Mine always had too
much friction

[Guest]

Hi,

Have you tried using simmerings?

They

Hi,

Have you tried using simmerings?

They seem to be the best choice for low friction.

Norbert sells them on his website.

Andy

[raalst]

Thnaks for replying andy !

I

Thnaks for replying andy !

I did try these, but it almost seemed they
were smaller than what I specified.
Unused, the diameter of the opening is about 3 mm
for a 4mm axle.

And maybe I did not get the right axle material.
At some places along the axle, it ran much easier
than others.
the real problem I faced is that the motor
must be mounted spot-on centered with the
simmerring (and possibly a ball bearing)
I could not pull that off.



Edited By raalst on 1096837666